Installation Guide and Users ManualUnder Cabinet Range HoodAirPRO 238 Professional Series (PS13/PS15/PS37)NOTICE:Installer: Leave this guide with the
IMPORTANT: Observe all governing codes and ordinances. (Please consult with a qualied electrician for 220-Volt 50 Hz voltage)It is the customer’s res
Page 9Figure 1 Figure 2PreparationAdvanced Preparations:Be familiar with the controls of the range hood by reading • through Range Hood Operations, Pa
Page 10InstallationFigure 3Figure 5Figure 4Installations (refer to Page 4 for parts):Measure the distance between stove top and the bottom of range ho
Figure 8Figure 7Page 11Installation (Continued)Figure 6 Figure 9Store excess wires in the wiring box.5. Drop oil tunnel into recess support near rear
Page 12Range Hood OperationsControl Panel Layout and Buttons Congurations:This range hood is equipped with remote control and heat sensor that will s
Page 13Range Hood Operations (Continued)Control Panel Layout and Buttons Congurations:Activating Light Function: • Press Light button once to turn
TroubleshootingPage 14If the range hood or halogen light does not operate 1. after installation:Check if the range hood has been plugged in, make • su
Use and Care InformationOperations:Read and understand all instructions and warnings in this manual before operating the appliance. Save these • instr
Measurements and DiagramsAll measurements in parenthesis are in millimeter.• All inch measurements are converted from millimeters, thus inch measureme
Page 17Rear Knockout Holes:All measurements in parenthesis are in millimeter.• All inch measurements are converted from millimeters, thus inch measure
Page 18Bafe Filters and Stainless Steel Spacers:36” Range Hood30” Range HoodCircuit Diagram:
Page 19Range Hood Assembly:No. Description No. Description1 Screws (3/16” x 3/8”) 12 Stainless Steel Spacer (Size Varies)2 Hood Casing 13 Bafe Filter
Page 20Blower Assembly:No. Description No. Description1 Air Chamber 8 Right Squirrel Cage2 Screw Cap 9 Gasket3 Left Squirrel Cage 10 Screws (3/16” x 3
Page 21Electrical Assembly:No. Description No. Description1 Electrical Box 7 Screws (3/16” x 3/8”)2 Screws (3/16” x 3/8”) 8 Transformer3 Processor Boa
Page 22WARNINGHazard of Burns!Light bulb become extremely hot when turned on. DO NOT touch bulb until switched off and cooled. Touching
Page 23One Year Parts Warranty:For one year from the date of original purchase, your local reseller will provide free of charge, non-consumable replac
Page 24Carefully inspect all items for damages before accepting delivery. note any damages on the freight bill or express receipt. request name and si
Your NotesPage 25
Cavaliere7372 Doig DriveGarden Grove, California 92841Tel: 714-622-1550 Fax: 714-622-1559http://www.cavalierehoods.com
Important Safety NoticeRead all Instructions before Installing and operating this applianceThe installation in this manual is intended for qualied in
Page 2Important Safety NoticeRead all Instructions before Installing and operating this applianceWARNINGYour safety and the safety of others is very i
Table of ContentsINSTALLATIONTools needed...3Parts supplied...
Page 4Parts supplied:Bafe FiltersBafe Filter SpacerHood-mounting Bracket (vary with model)Qty: 4 PCS(For sheet rock only)Qty: 4 PCSQty: 6 PCSPS13/PS
Ceiling HeightVenting RequirementsPage 5Height & ClearanceUnder Cabinet Range hood36” Counter TopMin: 27” Max: 30”Vent system must terminate
Page 6IMPORTANT:A minimum of 8” round (standard for this range hood) or 3-1/4 x 10” rectangular duct (purchased separate-• ly) must be used to maintai
Venting MethodsPage 7This range hood is factory set for venting through the roof or wall.• Vent work can terminate either through the roof or wall. To
Komentarze do niniejszej Instrukcji